HOMEPAGE

CONTACT US

TIPS FOR  NEW SCROLLERS

FREQUENTLY ASKED QUESTIONS

WHAT BLADE SHOULD I USE?

SCROLL SAW STARTER KITS

SCROLL SAW BOOKS

OLSON SCROLL SAW BLADES

FLYING DUTCHMAN SCROLL SAW BLADES 

DIAMOND SCROLL SAW BLADES

OLSON FRET LITE

FOREDOM FOOT SWITCH

2" STEEL SQUARE

SCROLL SANDERS

SCROLL SAW PATTERNS

SANDING SPONGES

SMALL DRILL BITS

OTHER SCROLL SAW PRODUCTS

WOODWORKING PLANS

LINKS TO OTHER GREAT SITES

ORDER FORM FOR MONEY ORDERS OR CHECKS

DRILL BITS

When scrolling you don't need all those big drill bits that you get when you buy a set. Here you can buy just the size you need.  Fraction sizes are 1/16", 5/64", 7/64", and 1/8". Numbered sizes are #58, #59, #60, #63, #65 and #67. On numbered drill bits, the higher the number the smaller the drill bit gets. (Remember, the larger the number on a scroll saw blade the larger the size of the blade. Just the opposite of numbered drill bits.) Price on any set of 12 is $6.99

#70 is good for blade size #3/0. Out of stock on #70.
#67 is good for blade sizes #2/0 and #3/0. Out of stock on #67.
#65 is good for blade sizes #0, 2/0 and below. Out of stock on #65.
#63 is good for blade size #0, #1 and below. Out of stock on #63.
#60 is good for blade size #2, #3 and below. Out of stock on #60.
#59 is good for blade size #4, #5 and below. Out of stock on #59.
#58 is good for blade size #6, #7 and below. Out of stock on #58.

1/16" is good for a blade size #7 and below.
5/64" is good for a blade size #9 and below.
7/64" is good for a blade size #12 and below.
1/8" is good for all pin end blades.

When scrolling, it is easier to use a larger drill bit then what I have listed above. You only need to use the smaller bits when the cut out in your pattern is smaller then the drill bit. 

If you would prefer to pay by money order or check please do all of your shopping and write down model # and prices so you will have that information handy. Then go to the Order form for money order or check page.